Cinside CPR4 Manual de usuario

1 | P a g e CPR CP22 Pager Quick Start Guide Basic Overview RTC Manufacturing has a hardware and software solution for agencies experiencing page

10 | P a g e Time switch programming will be displayed in either a CPR2102 or AP22 format, depending on which selection is made. There is also a se

11 | P a g e Files and CPR III programming CPR 4 Loader is compatible with all versions of CPR III. Specifically, versions 6.x, 7.x, 8.x and 9.x.

12 | P a g e To setup the communications, click ‘Utilities’ on the main screen. (Fig. 12) Fig. 12 In the Utilities box (Fig. 13), you will setu

13 | P a g e Fig. 14 Reading and Writing a Time Switch First, you need to select the type of time switch you are trying to connect to. In the

14 | P a g e Fig. 15 The next step is to connect the cable to the time switch. Once connected, you can validate communications by manually cont

15 | P a g e Fig. 17 After the read is finished, the results are shown. In Fig. 18 below, the time switch data does not match the computer data,

16 | P a g e Fig. 19

17 | P a g e Chapter 5 Using CP22 without a pager system in place Many users no longer have paging systems in place. Either the pager provider ha

18 | P a g e Chapter 6 Time without paging service If your paging service is working, all of your CPR2102 time switches (standard and CP22) will u

19 | P a g e Chapter 7 Changing schedule for weather or other immediate events If CPRIII 6.9 is being used with a working pager system, and the ti

2 | P a g e  CPR4 Loader This program is intended to be used to load time switches with programming. CPR4 Loader runs on any Windows XP or Windo

20 | P a g e Once you are satisfied with the events you have scheduled, click the ‘Program Holiday Plan’ button. Notice an H has appeared on the 10

21 | P a g e Fig. 24 Finally, click ‘Send Setup.’ The setups are then sent to the time switches with CP22 via the paging system, and programming

22 | P a g e Please send any comments and suggestions to. Mark Sampson RTC Manufacturing [email protected]

3 | P a g e Chapter 1 CP22 Chip Installation The CP22 chip must be installed in the CPR2102 time switch in order to make the time switch an annual

4 | P a g e Chapter 2 CPR III 6.9 software installation CPR III 6.9 is required for using the CP22 annual features. RTC supplies a CD with this

5 | P a g e Chapter 3 CPR III 6.9 Operation CPR III 6.9 is fully compatible with time switches that do not have the CP22 chip in them. This allow

6 | P a g e If you are using the paging system, the setup will be broadcast as a page. If you select COM Port, it will use the serial port to setup

7 | P a g e Once you send a page and it is verified, you will see the page arrive in the Received Pages area of the screen. In Fig. 6 below, the CP

8 | P a g e To program the time switch, click Send Setup (Fig. 7). At this time, either the pages go out, or the time switch is programmed using th

9 | P a g e Chapter 4 CPR4 Loader Instructions CPR4 Loader is meant to be used on a laptop computer on the bench or in the field. The program all